

0 out of 10. Some geriatric isn’t screaming about my geometric tollerences being off by a micron. /S
To be honest though, I remember learning far more when self-teaching and exploring than ever learning anything in lessons. Beyond the absolute basics of what each tool does and where to use it. I think it would be much more important to put an emphasis on that than an interface to tell somebody to click here and them not understand why they need to use that tool.
Make sure to spend some quality time on extrude and chamfer.



The main thing is log separation
It’s a lot easier to figure out why your service is broken if it’s the only service on the IP versus there being 10 services on the same IP all dumping into the same log. Lets me grep a lot easier